Landing gear (skids)

[Buman]

I am back with a brand new engine for my Raptor 50 V 50 (never run your engine with the needle almost closed [...] - yes tdswan :) ) and because I had to remove the landing gear I had to put it back but I noticed that the screws no longer hold it tight against the body (because it screwed on plastic ). Any recommendations ? I am thinking about using (longer) screws with washers instead. It is just that for the rear I couldn't find small washers at Home depot or Lowes that would fit in the rear cavity (I hope you know what I mean).

Thanks!

Buman

[tdswan]

Same thing on my Raptor, I just used bigger diameter screws that I had laying around in a junk drawer and made sure to CA them in and not overtight.