mcnscott
07-04-2006, 01:14 AM
hello,
I've spent hours dialing in my raptor 30 V2. My problem is I just can't get the heli to stop counterspinning. I have to put full right rudder trim when I'm not In HH mode, and then push the lever to the right a hair.
When I'm in HH mode the gyro puts so much right rudder on that the heli won't lift off the ground. I thought my mix was too rich because when I give it full throttle in HH mode the engine dies. I have adjusted the high needle from 3 turns out all the way to 1 turn out with the same result every time.
When the gyro HH mode is off and servo centered my rotor slider has the 4.5 mm space raptor techniques says. But I just can't get it to work right. Thank you!
I'm pretty sure the gyro is right, when I first started it spun wildly out of control, I reversed the gyro, and now it's still spinning just, spinning slow.
I've spent hours dialing in my raptor 30 V2. My problem is I just can't get the heli to stop counterspinning. I have to put full right rudder trim when I'm not In HH mode, and then push the lever to the right a hair.
When I'm in HH mode the gyro puts so much right rudder on that the heli won't lift off the ground. I thought my mix was too rich because when I give it full throttle in HH mode the engine dies. I have adjusted the high needle from 3 turns out all the way to 1 turn out with the same result every time.
When the gyro HH mode is off and servo centered my rotor slider has the 4.5 mm space raptor techniques says. But I just can't get it to work right. Thank you!
I'm pretty sure the gyro is right, when I first started it spun wildly out of control, I reversed the gyro, and now it's still spinning just, spinning slow.