Helifino
06-22-2006, 05:04 PM
Would anyone out there be willing to post or email me closeup pictures of their electronics setup on a Trex 450XL CDE?
The manual suggests mounting the receiver in the rear,but does not indicate were to mount the ESC.
My plan was to mount the receiver(hitec electron 6) in the front,but then It interferes with installing the canopy and/or servo links(whether it's installed vertical or horizontal).
If I place it in the rear,which is fine and there is plenty of room, it will be too close to the ESC(align 25 amp) causing possible interference. Or does it matter?.
Any pics of the tail servo setup would also be helpful.
The manual suggests mounting the receiver in the rear,but does not indicate were to mount the ESC.
My plan was to mount the receiver(hitec electron 6) in the front,but then It interferes with installing the canopy and/or servo links(whether it's installed vertical or horizontal).
If I place it in the rear,which is fine and there is plenty of room, it will be too close to the ESC(align 25 amp) causing possible interference. Or does it matter?.
Any pics of the tail servo setup would also be helpful.