tdswan
03-09-2007, 12:55 AM
Hey all. I just got done salvaging the old parts from my T-Rex 450XL CDE. I've got a few useable parts and some extras laying around. There's so many parts, this may take a while to type. Also, the pics don't show everything because I found some other parts while I was typing this out. MAKE ME AN OFFER!!! $4 shipping to the continental US.
Here's the list:
1x tail boom, NEW
1x flybar, NEW
3x boom supports, used
2x tail linkage rods 1new, 1 used
1x tail belt, recently replaced, but pretty much new
4x skids, used
3x landing struts, used
1x main gear, NEW
1x tail drive gear (one below main gear)
1x one-way bearing, still installed in stripped main gear.
2x tail servo mount SET
2x CARBON vertical tail fins
1x CARBON horizontal fin
3x main shafts
1x main frame, CDE
1x ENTIRE head minus main blade grips PLUS 1 bent flybar! with half-metal swash with plastic ring, glued in place....I can't tell, but I think the main shaft is NOT bent, so that takes the total to 4 if it's straight.
Here's the list:
1x tail boom, NEW
1x flybar, NEW
3x boom supports, used
2x tail linkage rods 1new, 1 used
1x tail belt, recently replaced, but pretty much new
4x skids, used
3x landing struts, used
1x main gear, NEW
1x tail drive gear (one below main gear)
1x one-way bearing, still installed in stripped main gear.
2x tail servo mount SET
2x CARBON vertical tail fins
1x CARBON horizontal fin
3x main shafts
1x main frame, CDE
1x ENTIRE head minus main blade grips PLUS 1 bent flybar! with half-metal swash with plastic ring, glued in place....I can't tell, but I think the main shaft is NOT bent, so that takes the total to 4 if it's straight.