G3

[redout]

Hey guys, I have a question for you anyone running the G3 sim. How can i config the controller for "idle up" as on the Blade CP TX ? Ive gone inverted on the sim but not on the "watt" heli. Any suggestions would be great. Thank you

[axis]

I have the G3 and on mine it is always in idle up mode.

[redout]

how do i get the "watt" to stay inverted then sir. When i inviert mine it slowly sinks to the ground.


Thank you sir.

[axis]

To get any of the heli's to feel "lighter" I adjust the trim tab all the way down on the collective stick. I'll fly the Watt tonight and see but basically it should just be a matter of more collective..

[opjose]

The upper left switch acts as an "Idle up" switch when it is in the middle or upper position.

The upper left switch on the front face will sometimes control dual rates dependant upon the model.

The Watt Not and some other electrics do not have 3D capabilities enabled.

If you wish to try to fly it inverted, EDIT the heli and adjust the pitch range from the current settings to -10, +10. That will permit the rotor to invert the pitch for upside down flight.

Note: you really want to copy the configuration from one of the other existing helis to also gain switched based control over the rotor head speed aka Idle Up modes 1 and 2.

It's simple to replicate this in G3.

Also see Vitek's modification the Add-on's disk 4's Concept CP heli. With a tiny bit of tweaking his mod duplicates an electric heli perfectly. His mod is available on the Knifedge Forum pages.